A

Point the absorbent tip downward. Place the absorbent tip in the urine stream for about 5 seconds to be thoroughly wet.
OR
B



Otherwise, urine can be collected into a clean cup and the absorbent tip can then be dipped into the cup for about 5-10 seconds until h the urine sample moves into the test window.
C



Re-cap the device and wait for colored bands to appear and read the results. Read the result in 10 minutes.
NOTE: Strong positive specimens may produce positive results in as little time as 1 minute. Confirm negatives in 10-20 minutes.A
Remove the testing device from the foil pouch by tearing it at the notch. Hold the strip at the colored end. Holding the strip vertically, immerse the end of the strip with the arrows into the specimen. Do not immerse past the MAX line.
B
Take the strip out when the sample has migrated to the test window (about 10 seconds). Lay the strip (MAX side facing up) flat on a clean, dry, non-absorbent surface.
Read the result in 10 minutes, following instructions under the “Result Interpretations” section